And that is the maximum speed I can have if I go up hill. I also notice that some times the car works fine, it gets good speed but once I start going up hill the speed get down to aprox 60km/h. Once I start driving, it turns off sometimes when I push the brakes or when I use the reverse (automatic). ![]() When I start the car it takes aprox 5 seconds or a little more to make the engine run, if I don't accelerate the engine, it will turn off. ![]() I replaced the MAF sensor before, because I read the benz forums and they mentioned similar problems but it did'nt work at all. P0335 crankshaft position sensor A circuit malfunction I run my OBD scanner (actron) and it shows two codes:ġ. I started having problems a few months ago, the check engine turned on and the car got all slow and having truble to turn on. Hi, this will be a little difficult to understand probably, because english is not my native language, but here it goes. Could this be a reason for not starting the car even though it cranks.Īny suggestions would be appreciated right now as we are going crazy trying to figure this out We are going to attempt to trickle charge the battery. With battery pack off it shows as 9 and when attempting to crank drops to 7. Ive decided to go ahead and replace both the front and back. Volt reader showed it as 9.3-9.4 with battery back on. While replacing my front brakes on my 05 C230 Kompressor Sport sedan I noticed the beginning wear signs of my front struts failing (the car 73K miles on it so its probably due for them to be replaced). We put a battery booster on the battery and it was still not cranking. Now when trying to crank the car we notices it was loosing juice. We hooked up back the odb2 and all codes and faults were gone except the overhead control which is the sunroof. Still crank no startĪfter doing more research we than ordered and replace the Crankshaft Position Sensor. We than ordered two cam adjuster magnets and replaced them. Ordered new sparks, replaced gaskets, cleaned and check coils that were producing spark. We than removed the valve cover took out the coils and noticed there was oil leaking into the sparks 1, 2 We put odb2 scanner in and read the codes as camshaft and misfire ![]() Mechanic and I started to try to figure out what is going on. Have been working on this issue for the last 9 days now.Ĭar started to idle rough and kept shutting off.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |